Enerpac EFBE5017, Инструкция

Страница: 18 / 24

18
1. Be sure that the cutter piston is fully retracted. If not, start
the cutter and cycle the piston until it is fully retracted.
NOTICE
If the piston will not retract in step 1, move the
piston release lever to position 2 to manually retract the
piston. Refer to instructions in Section 8.2. Also see
Figure 5.
2. Disconnect cutter from AC power supply to prevent
accidental motor startup during the following steps.
3. Place the cutter horizontally on a stable work surface
with the handle facing upwards.
4. Remove the moving blade screws and lock washers.
5. Remove the worn moving blade and replace it with
the new moving blade.
10.6.3 Blade Replacement - Moving Blade
Replace the moving blade as described in the following
steps. Refer to Figure 10, items 1, 2 and 3.
Figure 10, Moving Blade Replacement
1
3
2
NOTICE
If needed, use a screwdriver or small pry bar to
separate the worn moving blade from the mating surface
of the piston.
6. Secure the new moving blade with the new moving
blade screws and lock washers included with the new
moving blade. Apply Loctite 638 thread sealant (or
equivalent) to threads. Torque to 52.9 in-lb [5.98 Nm].
7. If piston release lever is in position 2, move lever
to position 1 to allow normal operation. Refer to
instructions in Section 8.2. Also see Figure 5.
8. Test cutter for proper operation before placing it back
into service.
Key:
1. Moving Blade Screws
2. Lock Washers
3. Moving Blade