User manual Cinne™ 3000. Ref: 201104
5/7
Satellite speakers connection
A. Setting up the satellite speakers.
ü
Befote connecting the satellite speakers to the
amplifier, make sure that the amplifier is
powered off and disconnected to any power
current.
ü
Make sure that the amplifier impedance is the
same than the speaker impedande (when
using a different amplifier from the one
included).
ü
Use a speaker cable with an approximate
thickness of 2mm
2
and not longer than 10
meters for avoiding signal loss.
ü
Connect the cable heads from the amplifier
output to the speaker input terminals.
ü
Make sure that the polarity are the same than
the ones shown in the image.
Connection between speakers and
amplifier
B. Speakers location.
Ø
Place the rear speakers in a rear side from the hearer position.
Ø
The high frequency speaker of the main channel of speaker should be located at the same elevation
than the hearer’s head.
Ø
The surround speakers should be located at one meter and a half from the floor.
Ø
The speakers position should remain parallel from each other and balanced from the position of the
hearer to maximize the 3D effect.
C. Maintenance instructions.
ü
Do not expose the speakers to direct sun light, extreme temperatures or high humidity.
ü
Keep the amplifier volume in a low position when powering on for avoiding damage to the speakers.
ü
Do not surpass the allowed potency, otherwise the sound quality will decline and the speakers could
suffer damage.
ü
Clean the speakers exclusively with a soft cloth.
ü
Do not place the speaker close to a TV set, for avoiding any magnetic interference.
Speakers
Amplifier
Speakers