Energizer eZV3200, Руководство пользователя

Страница: 32 / 48

24
1. Unscrew and remove the air filter maintenance panel.
2. Unscrew and remove the air filter assembly.
3. Remove the foam filter.
4. If the foam element is dirty, clean it in warm soapy water, rinse, and allow it to
dry thoroughly, or clean in non-flammable solvent and allow to dry.
5. Dip the foam element in clean
engine oil, then squeeze out
all excess oil. The engine will
smoke when started if too
much oil is left in the filter.
6. Wipe dirt from the air filter
assembly and reinstall into
the unit.
7.4) Spark Plug Service
Recommendation spark plug: F7TC
Check the spark plug gap and clean the carbon deposits at the bottom of the
spark plug. Do not rinse spark plug in water. Follow guidelines and be careful not to
overtighten the spark plug.
1. Remove the spark plug cap.
2. Remove the spark plug with the spark
plug spanner.
3. Visually inspect the spark plug.
Replace with a new one plug if the
insulation is cracked or chipped. Clean
with a wire brush if the spark plug is
reused.
4. Measure the spark plug gap with a
feeler gauge. The normal value is: 0.6-
0.7mm (0.024- 0.028in). Adjust the
gap by carefully bending the electrode.
5. Carefully reinstall the spark plug by
hand, to avoid cross-threading. A new
spark plug should be tightened 1/2
turn with a spanner. A used Spark
plug should be tightened 1/8 to 1/4
turn with spanner.
Filter
0.60-0.70mm
(0.024-0.028in)
Filter
0.60-0.70mm
(0.024-0.028in)
Filter
0.60-0.70mm
(0.024-0.028in)