Energie ECO100esm, Техническое руководство

Страница: 25 / 36

55
ECO100
English
Technical Manual
5.9. CRONO Function
The CRONO function allows you to program the unit to operate only at the desired time.
To set the ours of operation, perform the following procedures:
3. 1. 2.
4. 5.
1.
Enter the menu and access the parameter F03- Timer;
2. Select, for example, a weekly schedule (Monday to Friday);
3. Set the operating hours for each period.
4. Set the operating mode:
• M01 – The equipment starts operating within the programmed time periods. When not in the pro-
grammed times, it goes into Standby mode.
• M02 – The equipment starts operating within the programmed time periods as the TCC function.
When not in the programmed times, it goes into Standby mode, however whenever the TCC contact
is activated, the device activates the TCC function.
5. Activate the Timer function. Use the key
▲
to change the status and press OK to confirm.
6. START-UP OF THE SYSTEM
Before starting the ECO, check whether the installation is set up according to the recommendations
and that everything is in conformity, then you may plug your equipment to the power supply.
After switching on your equipment you should wait a few seconds until the controller begins to work.
Then you may start your equipment following these instructions:
1. Controller Initiation
2. System is shut off. Press key ON/OFF to torn on the system.
3. Press key COMP to start-up the system.
Note 1:
The LED on the ON / OFF button indicates the status of your device. If it is flashing, the equipment
does not have any operating order. If the light is on, your equipment is operating in one of the available
modes.
Note 2: To restart the machine, turn it off and then on using the ON / OFF button.
3. 1. 2.