4
www.energeticlighting.com
INSTALLATION INSTRUCTIONS
OPERATING INSTRUCTIONS
4. After mounting the fixture plug the power cord into a
grounded outlet to finish the installation.
Fig. 4
5
This fixture is warranted to perform free from defects for three years. If it fails to do so, you may
return it with proof of purchase to 13445 12th St., Chino, CA 91710 for replacement.
Clean with a mild, non-abrasive glass cleaner and soft cloth. Do NOT use solvents or clean-
ers containing abrasive agents. When cleaning the fixture, make sure the power is turned
off, and any liquid spray should be applied to the cleaning cloth and not sprayed directly onto
the fixture itself.
www.energeticlighting.com
CARE AND MAINTENANCE
TROUBLESHOOTING
WARRANTY
Problem
Possible Solution
Corrective Action
Fixture does not light.
Bluetooth
®
connection
cannot be established.
Poor sound quality from
speakers.
Power is off.
Reset power to fixture.
Rescan for available
devices from device settings
menu.
Device is out of range from
fixture.
Other wireless devices in
close proximity causing
interference.
Device settings may need
to be enabled or adjusted.
Check circuit breaker
or wall switch.
Unplug the power plug from
outlet, and plug back in.
Check device
Bluetooth
®
settings menu.
Ensure that device has
Bluetooth
®
enabled, also
check that device has
sufficient battery charge.
Ensure that the fixture is
within 32 feet (10 meters) of
the
Bluetooth
®
device and
check for obstructions
between device and fixture.
Try relocating source device
away from other
Bluetooth
®
or Wi-Fi devices, or try turning
off other devices to see if
connection can be restored.
Check device volume is
not muted or set too low.
Check if the phone has any
low battery power
management regulating
Bluetooth
®
connection.
1. The light can be switched on and off by using the pull
chain. The speakers will continue to work whether
the light is on or off, as long as connection to
bluetooth device is maintained.
Fig. 1
2. To connect the shoplight to your Bluetooth
®
device,
plug in the shop light fixture to power on the speakers
(shop light LED illumination does not need to be
switched on), then listen for a double chime sound
from the speakers.
Enter the Bluetooth
®
menu on cell phone or other
source device and access the list of
“Available Bluetooth
®
Devices”.
Check the list of available devices on the Bluetooth
®
device to see if “SL-******” (where * stands
for a unique number) is detected. The list may need to be refreshed, or manually scanned for
new connections. Select the “SL-******” name to pair device with the fixture. Once connection
is established, the fixture speakers will emit a single chime.
If “SL-******” is not available after 1 minute of powering on, unplug the fixture power cord and
plug back in to reset the speakers.
Volume can be adjusted from your source Bluetooth
®
device.
Please note that only one Bluetooth
®
device can be connected to each fixture, and only one
fixture can be connected to each Bluetooth
®
device.
Typical connection range is approximately 32 feet (10 meters), and connection reliability may be
affected by obstructions within the room. If interruptions occur during streaming, try relocating
the Bluetooth
®
device to a different location.
Fig. 2
Available devices
...
...
...
SL-******
Bluetooth Settings
