4
5
INSTALLATION INSTRUCTIONS
INSTALLATION INSTRUCTIONS
DD
2. Attach crossbar (DD) to outlet box (not included)
using short screws (AA).
2
AA
CC
3. Connect the fixture wires to the supply wires -- black
to black, white to white, and green to copper/bare.
WARNING:
If there is no ground supply wire, stop
installation and consult a qualified
electrician.
Once wire connections are made, secure each with a
wire nut (CC).
3
A
4. Lift fixture pan (A) up toward ceiling and carefully tuck
wires into outlet box. Align keyholes on fixture pan
(A) with long screws (BB), then twist fixture pan (A)
until the long screws (BB) engage the narrow end of
the keyholes. Tighten long screws (BB) to secure.
4
DD
Hardware Used
AA
Short
Screw
x
2
Hardware Used
Wire
Nut x
3
CC
www.energeticlighting.com
www.energeticlighting.com
A
6. Align the tabs on fixture pan (A) with the
channels on diffuser (B), then insert
diffuser (B) into fixture pan (A).
Carefullly twist the diffuser (B) clockwise
until secure.
CAUTION:
Make sure the upper lip of
diffuser (B) is secured completely by the
tabs on fixture pan (A). If not, the
diffuser (B) could potentially fall and
break.
6
5. This fixture allows the correlated color temperature
(CCT) of the LEDs to be adjusted from warm white
(3000K) to cool white (5000K) as desired. The
wattage can also be adjusted to a lower level if a fixed
lower light level is desired for fixture location. Before
proceeding to the next step, the CCT switch and
Wattage switch should be set to the desired positions
by moving the toggle switch through the range of
detents or clicks and following the position markings
next to each switch.
5
CCT select switch
Wattage select
switch
A
BB
B