NOTICE
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on. The
user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
3
2
PACKAGE CONTENTS
SAFETY INFORMATION
•
-
-
-
-
HARDWARE CONTENTS
(shown actual size)
BB
Long Screw
Qty. 2
AA
Short Screw
Qty. 2
CC
Wire Nut
Qty. 3
DD
Crossbar
(Not to scale)
Qty. 1
Please read and understand this entire manual before attempting to assemble, operate or
install the product. Failure to do so could lead to electric shock, fire or other injuries that
could be hazardous or even fatal.
Be sure the electricity to the wires you are working on is shut off. Either remove the fuse or
turn off the circuit breaker.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
CAUTION:
The fixture body is one piece. Do not disassemble it.
This fixture is dimmable with most phase-cut triac dimmer switches, for the latest
compatibility list, please visit www.energeticlighting.com.
NOTICE
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Before beginning assembly of product, make sure all parts are present. Compare parts with
package contents list and hardware contents list. If any part is missing or damaged, do not
attempt to assemble the product.
Estimated Assembly Time:
15 minutes
Tools Required for Assembly (not included): Phillips Screwdriver
SAFETY INFORMATION
•
•
•
•
•
INSTALLATION INSTRUCTIONS
PREPARATION
Hardware Used
1. Align two of the threaded holes on crossbar (DD) over
one set of keyhole slots on the fixture pan (A). From
the inside of fixture pan (A), insert long screws (BB)
into aligned holes, leaving about 1 in. of space
between the screw heads and crossbar (DD).
Note:
Do not install fixture pan (A) yet.
A
BB
1
DD
Long
Screw
x
2
Crossbar x
1
BB
DD
www.energeticlighting.com
www.energeticlighting.com
Part
Item Name
Qty.
A
B
Fixture Pan
Diffuser
1
1
A
B