4
www.energeticlighting.com
www.energeticlighting.com
INSTALLATION INSTRUCTIONS
INSTALLATION INSTRUCTIONS
2. Swing the lens front cover (A) open and slide the lens
cover off the two hinges in the direction as shown, set
aside the lens cover.
Fig. 2
3. Turn out the through hole plug at the center of the
junction box mating face by using a philips head
screwdriver (not included).
Fig. 3
6.
Ensure that power is shut off and
connect the supply
wires to the fixture wires -- black to black, white to
white, and green to copper/bare.
WARNING:
If there is no ground supply wire, stop
installation and consult a qualified electrician.
Once wire connections are made, secure each with a
wire nut (AA).
For models E2WPA36L and E2WPA60L:
OPTIONAL:
If fixture is to be used with a 0-10v
dimming system, connect the purple and gray leads
to the respective purple and gray dimming leads.
CAUTION:
Dimming leads can only be used with low
voltage DC voltages within 0-10Vdc. Connecting
these wires to AC or higher voltages will damage
driver and may render fixture inoperable.
5
7. Tuck the wires and wire nuts (AA) inside the fixture
compartment while closing the front cover (A).
Ensure that wires are not pinched along the perimeter
seam, and that the gasket around the edge is not out
of place.
Fig. 7
Fig. 6
Fig. 5
4. Align the junction box to the housing pattern moulding
and determine the appropriate set of mounting
through-holes to drill out for the junction box screws
(BB) used to secure the fixture to the mounting
surface.
Prior to mounting the back plate to the mounting
surface, apply silicon sealant (not provided) around
the perimeter of the junction box to seal out water
from entering the wiring compartment. Feed the
supply lines from the junction box to the inner side of
the back plate (B). Line up the junction box mounting
holes on the back plate (B) to the threaded holes on
the junction box and secure the plate to the wall with
the four junction box screws (BB).
Fig. 4
Seal with
silicone
sealant
5.
Replace the front cover (A) onto the back plate (B)
secured through the two side hinge receivers, ensure
that the front cover (A) is secured prior to releasing
hold of the front cover (A).
B
B
B
A
A
A
B
A
B
BB
B
AA
0-10v Dimming
(Optional)