4
Mark drill location on
mounting surface
centered over supply
wires
Drill pilot holes for
screws or anchors
Wiring compartment
cover
1/2-inch
www.energeticlighting.com
5
www.energeticlighting.com
INSTALLATION INSTRUCTIONS
Fig. 3
3. Hold fixture up to supply wire location on mounting
surface, mark off 3 drill location for mounting screws.
4. Drill out appropriate mounting holes depending on
mounting surface material, use anchors (not supplied)
if surface cannot support the weight of the fixture with
only wood screws (BB). Pre-install the two bottom
screws and leave about 1/2-inch clearance between
screw head and mounting surface.
Fig. 4
5. Pass supply wires through wiring compartment cover
that was removed from step 2.
Connect the fixture wires to the supply wires --
black to black, white to white, and green to
copper/bare.
WARNING:
If there is no ground supply
wire, stop installation and consult a qualified
electrician.
Once wire connections are made, secure each with a
wire nut (CC).
Fig. 5
INSTALLATION INSTRUCTIONS
7. Replace the diffuser (B) by inserting the two screws
on fixture (A) through the larger opening of each
keyhole slot on diffuser, rotate diffuser until screws
can be tighted to secure diffuser (B).
Fig. 7
6. Seat the fixture mounting flange over the two
pre-installed screws (BB), using a low profile
screwdriver, install the last screw (BB) on the upper
mounting hole.
Tuck the wires and wiring nuts carefully into the wiring
compartment, and using the two wiring compartment
cover screws removed from step 2, seal the wiring
compartment.
Fig. 6
Clean with a mild, non-abrasive glass cleaner and soft cloth. Do NOT use solvents or clean-
ers containing abrasive agents. When cleaning the fixture, make sure the power is turned
off, and any liquid spray should be applied to the cleaning cloth and not sprayed directly onto
the fixture itself.
CARE AND MAINTENANCE
BB
BB
B
A
A
AA