4. DUST COLLECTION DEVICE (Fig.5)
NOTE:
The dust cap is ideal when working overhead
(vertically). It protects the user from falling dust which may
restrict vision.
1. Before fitting the drill bit, pull the dust cap down the
length of the drill bit ensuring the recessed end of the
cap is pointing towards the tip of the drill bit.
2. Fit the drill bit into the chuck.
3. Adjust the dust cap before use so that it does not rest
on the cutters of the drill bit.
5. ON/OFF SWITCH
Depress the On/Off switch to start and release it to stop
your drill.(Fig.6)
6. REPLACING OF CARBON BRUSHES
The carbon brushes are expendable. It is keeping abrasion
during use.
The carbon brushes should be changed regularly. In order
not to damage the electrical circuit, both carbon brushes
should be changed at the same time.
CAUTION!
The machine should be used only with both brushes!
Fig.5
Fig.6
On/off switch
Dust
Cap
750W ROTARY HAMMER ENB569DRL
The pressure that is applied to the switch will determine the
speed. The more pressure that is applied, the faster the
speed. And the operating speed can be set by using the
speed adjustment knob.
To increase or decrease rotary speeds, move the knob.
If using the speed adjustment knob, the drill will
automatically run at the predetermined speed when the
trigger switch is fully depressed.
