Energer ENB540DBT, Инструкция по эксплуатации

Страница: 10 / 33

10
it is kept well away from electrical components. Never use water as a coolant.
Keep drills and other cutters sharp and in good condition. This will improve cutting
and reduce the load on the machine ensuring a longer life of the cutting tools
and the machine.
- Use only drill bits, cutters and other accessories recommended by the
manufacturer. Select the correct spindle speed for the size of drill being used.
See the instruction manual. Do not attempt to modify the machine or its
accessories in any way.
- Do not force the machine, let the machine do the work. This will reduce the
wear on the machine and cutter and increase its efficiency and operating life.
- Use approved safety glasses or goggles at all times, and a face mask and ear
defenders when using for prolonged periods.
- When drilling long lengths of material ensure that there is adequate support at
both ends of the material.
Never use the machine without the safety guards in position and operating
correctly.
- When drilling wood and wood type materials, ensure that the work piece is free
from any nails or other foreign objects that could damage the drills and other
cutting tools.
- Always secure the workpiece in a suitable drill vice.
- Never try and secure the workpiece with your hands.
- Be aware that swarf can be very sharp and hot and can fly off the rotating drill.
When handling swarf always wear suitable gloves. Swarf should not be
disposed of with domestic waste, it should be disposed of at a recycling centre.
- Never leave the machine running while unattended. If you are interrupted when
operating the drill, complete the process and switch off before looking up.
- Always allow the machine to come to a complete stop and disconnect from the
power supply before leaving the unit unattended.
- Never use your hands to remove dust, chips or waste close by the drill bit.
Even when the tool is used as prescribed it is not possible to eliminate all residual
risk factors. The following hazards may arise in connection with the ｔｏｏｌ抯
construction and design:
- Contact with the drill bit.
- Kickback of work piece and parts of workpiece.
- Bit fracture.
Technical and legal information
GB
IE
In
m
o
re
d
e
ta
il
..
.
ENB540DBT by ENERGER