2000W HEAT GUN ENB467HTG
3. THERMO-PROTECTION SWITCH-OFF
When the heater is overloaded (e.g. as a result of restricted
air flow), the unit switches it off automatically, however, the
blower continues to run. When the unit has cooled to
operating temperature, the heater is switched on again.
3. SETTING THE AIR FLOW AND TEMPERATURE (Fig.5)
The switch can be set to two blower steps. Suitable air flow
and temperature combinations can be selected according to
the applications.
I =450
℃
300l/min
II =600
℃
500l/min
The air setting 1 is suitable for Bending Plastic and heating
shrinking plastic.
The air setting 2 is suitable for stripping paint and defrosting
pipes.
Note:
The ideal temperature should first be ascertained by
performing a test. You should start with a low temperature
setting. The working temperature can vary depending on the
properties of the workpiece. The distance between the
nozzle and workpiece is dependent on the material to be
processed.