3.
INSTALLATION
3.1.
PRELIMINARY PROCEEDINGS
After the unpacking, check the battery in order to exclude possible mechanical damages. Don’t use the battery if
damaged. If you are not sure, pls. contact your supplier.
Verify the correct polarity of the whole plant that you will connect. The polarity is indicated on the connector of
the battery through the following symbols :
+
positive
-
negative
3.2.
PLACE OF INSTALLATION
Set the battery far from possible heat sources. Pls. look at the specifications contained in the chapter
“ TECHNICAL DATA “ in order to find the allowed working temperature.
In case of installation on vehicles , the battery case must be suitably protected from water splashes , sunbeams
and errant objects. Block the battery in a safe way, using, if necessary , some spongy material in order to fill the
box.
3.3.
CONNECTION
Use the cables for the appropriate section power connection. We advice to connect before the first negative
pole and then the positive one.
IF NOT PRESENT, PUT A FUSE WITH AN APPROPRIATE VALUE BETWEEN THE BATTERY AND THE PLANT.
IT’S NOT ALLOWED THE REPLACEMENT OF THE SCREWS PRESENT ON BATTERY POLES WITH OTHER SCREWS OF
DIFFERENT LENGHT.
3.4.
BATTERY CHARGER
Like all the Litio technology batteries, ENERGA batteries must be charged with suitable battery chargers
properly tested in the max current and max tension of end-charge.
The battery charger must work in a “ CONSTANT CURRENT” regime that must not exceed the max allowed
recharge current ( look at the chapter TECHNICAL DATA
max charge current
), until the reaching of the “end-
charge” tension ( look at the chapter TECHNICAL DATA
max end-charge tension
) and go on with a “
CONSTANT CURRENT” regime until the natural zeroing of the supplied current.
Moreover, in order to gain a longer life for battery we advice to charge it with a current not over the capacity
declared from the battery ( for example on the model 13-5° the capacity is 5 A/h and so you need to charge it
with not more than 5 Ampere ).
4.
MAINTENANCE
The only maintenance needed from battery is the visual control of the connections on poles that
haven’t to be slow or oxidized.
4.1.
MAINTENANCE e/o PRESERVATION
For vehicle stop period
over than 1 week
, being however a little absorption of current from junction box,
anti-theft device etc.. , you need to maintain the battery charged, using the appropriate maintainers ( look at the
chapter
BATTERY CHARGERS
) because the
little
Litio batteries, damaged seriously themselves in case of
excessive discharge ( tension lower than 8 Volt ).
