www.enerdrive.com.au
Page 8
SOLAR CHARGE CONTROLLERS
Features
•
4 Stage charging ensures the battery is charged to the optimum level (Bulk, Absorption,
Equalisation and Float)
•
Advanced MCU control pulse width modulated (PWM) technology
•
Programmable for Gel, AGM and Conventional Flooded batteries
•
Built in regulator to prevent your battery from being overcharged. Overcharging occurs when the
charge voltage is unregulated. This can result in premature battery failure
•
In built regulator prevents your battery from being under charged. In the solar energy field,
battery undercharging often occurs, especially on some conventional Lead Acid batteries. This
unit provides an automatic equalization feature for deeply drained conventional Lead Acid and
AGM batteries, as well as providing a cycling automatic equalizing feature every 28 days
•
The Solar Controller can be connected to the battery permanently to keep the battery fully
charged by using a process called “floating”. This means the controller will stop charging when the
battery is full and will automatically start charging the battery as required. This process will also
reduce water loss and help prevent the battery from ‘drying out’
•
Protects the battery from discharge at night. Under low light or no light conditions the solar panel
voltage could be less than the battery voltage. The unit contains a special circuit which prevents
current flowing back from the battery and into the solar panel
•
LCD display design, dynamically displays device’s operating data and working condition including
solar/battery/load information
•
Dual USB ports (5VDC/2.4A combined Max output) allow power supply charge for electronic
equipment
•
Remote Temperature Sensor (RTS) port built-in. Optional sensor probe available PN# EN43-TEMP
(Temp compensation will be fixed at 25°c without the RTS installed).
•
Multiple protections against reverse polarity, short circuit, over temperature, over voltage, etc.
•
IP Rating: IP30
