Enerdrive EPL-100BT-12V, Руководство пользователя, Страница: 6 / 20

Enerdrive ePOWER B-Tec Lithium Battery- Owners Manual (Rev. 3.01) Page 6
3 WARNINGS
Please read and follow the cautions listed on the battery before installation. Improper use may
cause heat, fire, rupture, damage or capacity deterioration of the battery. Enerdrive Pty Ltd is not
responsible for any accidents caused by the usage without following our specification.
WARNING!
Failure to follow these instructions may result in early
battery failure or possible personal injury.
• Do not use the battery for cranking/starting applications.
• Do not parallel or series connect the battery.
• Do not dispose of in fire.
• The battery must be installed far away from heat sources, high voltage, and avoid exposed
sunlight for long periods of time.
• Do not throw the battery into water.
• Do not connect the positive and negative terminals of battery together.
• Do not ship or store battery together with metal.
• Do not disassemble the battery. Battery warranty will be voided if the case is opened.
• Do not drop, impact or puncture the battery.
• Do not allow the battery to sit in a discharged state≤11.50V
• When the battery capacity is low (≤15% SOC), please charge the battery.
• Please use the matched or suggested charger that contains a Lithium charge profile for this
battery. Failure to install the correct battery charger will void all warranty.
• If the battery emits a peculiar smell, heating, distortion or appears to have any abnormality
during operation or storage, please stop using the battery and take it out of service. Contact
Enerdrive for further details
• If the battery leaks and gets into eyes or on skin, do not wipe. Rinse with clean water and seek
medical attention immediately.
Low Battery Voltage Disconnect
The battery has a low voltage disconnect incorporated for self-protection. If the battery is drawn down
to the internal low voltage disconnect set point (2.8v per cell) or (≤11.2V) the battery will disconnect.
To reconnect, a charge voltage of ≥12.8v must be applied to the battery before the over-discharge
release will activate and allow charge current to flow into the battery.
Enerdrive strongly recommend keeping the battery charged to avoid activating the low battery
voltage disconnect.