Enerdrive EPL-100AH-12v-BATT, Руководство пользователя

Страница: 4 / 13

V1.0 1/2015
What’s in the Enerdrive Lithium System?
To use the Enerdrive Lithium Power Pack you need to use two items together. These are:
• The actual lithium power pack battery box.
• The Advance BMS controller board which includes
• The Advance BMS Relay Driver box
• The ePRO Battery Monitor for accurate monitoring and control of the battery pack’s state of charge. This
monitor also logs historical data on the batteries usage and provides the trigger switch for a low SOC% or
Low Overall voltage. The monitor is pre-programmed with all of the alarm set points to match the specific
installation. The meter will show all of the relative information like Volts, Amps, Amp-hours, Percentage State
of Charge & Time to go. It will also record all of the history data of the Lithium battery, Deepest Discharge,
Battery Cycles, Hi/Low Voltage & Amps, All Alarm History Etc. This is a critical part of the Lithium battery
installation kit.
• A Blue Sea 500amp main battery latching relay which is activated by the ePRO Battery Monitor when the
low state of charge (percentage is reached).
• A Class T Fuse for system protection.
• 95mm² Battery cable from the battery to the Connection Kit.
1
2
3
4 5
6
7
8
9
10
11
12
1. Charge battery indicator
2. Numeric value indicator field
3. Setup lock / Master lock indicator
4. Main battery or Auxiliary battery indicator
5. State-of-charge bar
6. Charging in progress indicator
7. Alarm activated indicator
8. Readout units
9. Synchronize indicator
10. Next value or Right key (>)
11. Menu key
12. Previous value or Left key (<)