Eneo VKCD-13100F2810, Инструкция по установке и эксплуатации

Страница: 43 / 56

43
7.4 DAY/NIGHT Menu
To enter DAY/NIGHT menu, press button at MAIN menu-1 > DAY/NIGHT.
IMPORTANT ACTIVITY !!!
DAY –> NIGHT and NIGHT –> DAY operations must be examined and verified at the final installation.
Block the lens for a few seconds for NIGHT mode and release and let it return to DAY mode.
If camera stays at NIGHT mode more than 10sec, decrease NIGHT –> DAY THRES a little and repeat the
fore-mentioned steps.
If the scene is too dim or lens iris was adjusted too low (near close), it may not return to DAY.
DAY/NIGHT Default Descriptions
BURST OFF
BURST determines whether a colour burst signal keeps output or eliminated when
camera switches to B/W.
If set to ON, B/W video signal contains colour burst signal and is compatible
with the colour equipment but shows the same resolution as colour video.
If set OFF, the colour burst signal is removed from B/W video and shows better
resolution but rarely the compatibility problem may occur with the colour
equipment.
IR OPTIMIZER OFF
IR OPTIMIZER feature can reduce the over-saturation in video caused by the
narrow emitting IR LEDs
OFF – Disables IR OPTMIZER
ON – Enables IR OPTIMIZER
MODE AUTO
There are two modes available by how to manage IR OPTIMANAGER.
AUTO – Reducing the over-saturation is automatically adjusted along with the
location of the subject.
CENTER – Center area is prioritized to reduce the over-saturation.
Over-saturation in the side area could be ignored.
LEVEL 015
Overall brightness is adjusted when IR OPTIMIZER is working.
High value in LEVEL increases the brightness but the over-saturation could occur.
Low value in LEVEL decreases the brightness and the dim area could be darker.