Eneo Rapport III, Инструкция по эксплуатации

Страница: 4 / 24

SAFETY INFORMATION
Precautions
The following describes how to safely operate the
Rapport III.
Please read carefully "the precautions for use of this product" prior to
using this device. Check the input and output ranges of any voltages
being applied to all inputs and outputs of the device, and ensure their
connections have been made properly so no abnormal load is placed
on the operation of the device. If the measurement value is unknown
when measuring a resistance, set the Rapport ill meter to its maximum
value so that no abnormal load is placed upon the device.
The Rapport in should only be used under the environmental
conditions shown in the specification where temperature and humidity
figures should be adhered to.
Before using the
multimeter function for
circuit testing, always
disconnect all Video
In/Out connections made
to any other external
devices. Connecting the
Test Lead Set to a circuit
for testing, with these
connections made,
causes them to use a
common grounding path
and could result in
damage to the device.
SAFETY INFORMATION
Precautions
Pay attention to the following precautions when using the
Rapport III.
■ Do not use the unit in damp, humid or gaseous environments.
■ Do not touch it with wet hands.
■ Be mindful not to shock or shake the unit while in use to avoid damage.
■ Avoid areas with strong magnetic or electromotive fields, which can cause
incorrect measurements or operability.
■ Do not expose the ports or joints to dirt or liquids.
■ Do not disassemble the Rapport ill.
■ Do not use the meter function, if the Rapport ill or the Test Lead set look
damaged.
■ Do not measure resistance when power is applied to a circuit.
■ When using the meter function, do not forget to turn on the power to
■ the Rapport ill and use the correct measurement range before connecting to
a circuit to be measured.
■ Turn off the power to the circuit under test and discharge all high voltage
capacitance before starting resistance or continuity tests to avoid damage to
the Rapport ill.
■ Place fingers behind the protecting pad when using a test probe.
06 07
MONITOR
DC POWER SUPPLIES