Eneo AK-4, Быстрое руководство по установке

Страница: 12 / 26

12
Camera assembly
1) Remove the push-out on the rear-side of the terminal box.
Trim the edge of the hole with a file, and press the membrane bushing into
the opening from the rear-side.
2) Drill the wall holes in accordance with the distances specified in the dra-
wing. Whilst doing this, pay attention to the correct positioning of the cable
entry!
3) Insert the wall plugs into pre-drilled holes.
4) Puncture the membrane for each separate cable and feed the cables
through the seal into the terminal box.
5) Position the terminal box over the bore holes.
6) Secure the terminal box with the wall fixing screws.
When using the rear-side cable entry
1) Drill the wall holes in accordance with the distances specified in the
drawing.
2) Insert the wall plugs into pre-drilled holes.
3) Position the terminal box over the bore holes.
4) Secure the terminal box with the wall fixing screws.
When using the M20x15 screw fittings
1) Remove the upper screw part and the seal insert from cable entry found
in the lid.
2) Feed the cable from outside through the screw connection and the cap.
3) Insert the cable via the lateral slot into the matching hole of the seal.