EndRun RTM3204, Руководство пользователя

Страница: 22 / 66

R T M 3 2 0 4 G P S T i m i n g M o d u l e U s e r M a n u a l 12
C H A P T E R T W O
13 R T M 3 2 0 4 G P S T i m i n g M o d u l e U s e r M a n u a l
B A S I C I N S T A L L A T I O N
Will your Tycho GPS be accessing a nameserver ([y]es, [n]o)? y
Set the IP address of the primary name server to use for domain your.domain.
Enter primary name server IP address (aaa.bbb.ccc.ddd): 192.168.1.1
Will your Tycho GPS be accessing a secondary nameserver ([y]es, [n]o)? y
Set the IP address of the secondary name server to use for domain your.domain.
Enter secondary name server IP address (aaa.bbb.ccc.ddd): 192.168.1.2
Setting up TCP/IP...
Creating /etc/HOSTNAME...
Creating /etc/rc.d/rc.inet1...
Creating /etc/networks...
Creating /etc/hosts...
Creating /etc/resolv.conf...
*******************************************************************************
*******************************************************************************
* *
* The Tycho GPS network configuration has been updated. *
* *
* Please re-boot now for the changes to take effect. *
* *
*******************************************************************************
*******************************************************************************
Verify Network Configuration
If you have made changes to your network configuration using
netconfig
, you should shutdown the
RTM3204 and re-boot it. There are two ways to do this:
1. Cycle power to the RTM3204.
2. Issue the shutdown with re-boot command at the shell prompt:
Tycho GPS (root@gsys:~)-> shutdown -r now
If you are using the RS-232 serial I/O port to communicate with the RTM3204, you will be able to
see the kernel generated boot messages when the unit re-boots. You should note the line
Configuring eth0 as 192.168.1.245...
if you have set up a static IP address, or this line
Attempting to configure eth0 by contacting a DHCP server...
if you are using DHCP. It appears near the end of the kernel generated boot messages.
If you are using DHCP and are not using the RS-232 serial I/O port, you will have to check the DHCP
configuration information maintained by your DHCP server to determine the expected IP address and
log in to the RTM3204/Tycho using
telnet
or
ssh
to verify successful DHCP configuration. Refer
to the subsequent topics in this section
Using Telnet
and
Using SSH
, for details on logging in to the
RTM3204 that way. Once you have logged in, you may perform the following checks.
If you are not using DHCP, the IP address shown should match the static IP address which you
entered during the
netconfig
procedure. If so, log in as “root” at the login prompt and check the