EndRun FDC3300, Руководство пользователя

Страница: 32 / 40

F D C 3 3 0 0 U s e r M a n u a l 22
A P P E N D I X C
23 F D C 3 3 0 0 U s e r M a n u a l
N E T W O R K P O R T O P T I O N
Detailed Command
Descriptions
netconfig
This command queries or sets the IP network addressing parameters that are stored in FLASH. After
setting new addresses, enter the
netreset
command for these settings to take effect on the network
port. Command syntax is:
netconfig=d,i,n,g,p,s
d is ON or OFF to enable or disable DHCP.
If DCHP is ON, then enter the command as:
netconfig=ON
. No other fields are necessary.
If DHCP is OFF, then enter these remaining fields:
i is the IP Address 111.222.333.444
n is the Netmask 111.222.333.444
g is the Gateway Address 111.222.333.444 or hyphen ‘-’ if you are not using one.
p is the primary DNS Address 111.222.333.444 or hyphen ‘-’ if you are not using one.
s is the secondary DNS Address 111.222.333.444 or hyphen ‘-’ if you are not using one.
In the example below the user is disabling DHCP and setting the IP address, netmask, gateway and the
primary DNS address. The secondary DNS is not used.
Set:
netconfig = OFF,192.168.1.135,255.255.255.0,192.168.1.1,192.168.1.1,-
Chassis response:
OK
Reset network port (“netreset”) for these settings
to take effect.
Query:
netconfig
Chassis response:
netconfig = OFF,192.168.1.135,255.255.255.0,192.168.1.1,192.168.1.1,0.0.0.0
Factory default setting:
netconfig = ON
netmac
This is a query-only command shows the Media Access Control (MAC) address of the ethernet network
port.
Query:
netmac
Chassis response:
netmac = 0:20:4a:94:32:ae
netpass
This command sets the password for accessing the network port via Telnet or SSH. The password must
be at least 8 and less than 32 characters. Characters must be alphanumeric or the underscore ‘_’. Enter-
ing control-C will quit without changing the password. There is no query mode for this command.