Endress ESE 3000 i, Перевод инструкции по эксплуатации, Страница: 32 / 63

32
Commissioning
NOTICE!
Your generators will be delivered without any engine oil in it.
► You must fill the engine with engine oil before using it for the first time as de-
scribed in Chapter 9.3.2 .
Electrical start 1. Turn the tank ventilation valve on the tank cover Fig. 6-2 into the "ON"
position.
2. Open the fuel valve by turning the rotary knob into the “I“ position.
3. Pull the choke lever fully for a cold engine, somewhat less for a hot en-
gine.
4. Press and hold down the engine start switch in position “II“.
The engine starts.
The green operation indicator light
lights up.
5. Release the engine start switch .
6. Push the choke lever back in again slowly. If the engine begins to run un-
evenly, pull out the choke lever out a little for a short time and repeat the
process.
The motor runs at a stable speed.
You can connect to one piece of power consuming equipment.
You can use ECO mode (see Chapter 8.2 .
NOTICE!
Only activate the starter briefly (max. 5-10 seconds). Never start or run the
engine with the battery disconnected.
Fig. 7-3 Operating controls for an electrical and a manual start