Endress+Hauser SpectraSensors J22 TDLAS, Руководство по эксплуатации

Страница: 68 / 150

Operating Instructions J22 TDLAS Gas Analyzer
68 Hauser
7.12 Configuring the switch output
The switch output wizard guides you systematically through all the parameters that can be set for configuring the
selected output type.
Navigation Setup menu → switch output
▸ Switch output 1 to n
Operating mode → 
Terminal number → 
Signal mode → 
Switch output function → 
Assign diagnostic behavior → 
Assign limit
→ 
Assign status → 
Switch-on value → 
Switch-off value → 
Switch-on delay → 
Switch-off delay
→ 
Invert output signal → 
Parameter overview with brief description
Parameter Prerequisite Description User entry Factory setting
Operating
mode
— Define the output as a switch
output.
Switch Switch
Terminal
number
— Shows the terminal numbers
used by the switch output
module.
• Not used
• 24-25 (I/O 2)
• 22-23 (I/O 3)
—
Signal mode — Select the signal mode for the
switch output.
• Passive
• Active
• Passive NE
Passive
Switch
output
function
— Select function for switch output. •
Off
• On
• Diagnostic
behavior
• Limit
• Status
Diagnostic
behavior
Assign
diagnostic
behavior
In the Switch output
function parameter, the
Diagnostic behavior option
is selected.
Select Diagnostic behavior for
switch output.
• Alarm
• Alarm or
warning
• Warning
Alarm
Assign limit In the Switch output
function parameter, the
Limit option is selected.
Select process variable for limit
function.
• Off
• Concentration
• Dew point 1 1
Off
1
Options may be dependent on other parameter settings.