Promonitor NRF 560
Hauser
33
10.2
Return
The following procedures must be carried out before a transmitter is sent to Hauser e.g.
for repair or calibration:
• Remove all residue which may be present. Pay special attention to the gasket grooves and crevices
where fluid may be present. This is especially important if the fluid is dangerous to health, e.g.
corrosive, poisonous, carcinogenic, radioactive, etc.
• Always enclose a duly completed "Declaration of contamination" form (a copy of the "Declaration
of contamination" is included at the end of this operating manual).
Only then can EHauser transport, examine and repair a returned device.
• Enclose special handling instructions if necessary, for example a safety data sheet as per EN 91/155/EEC.
Additionally specify:
• An exact description of the application.
• The chemical and physical characteristics of the product.
• A short description of the error that occurred (specify error code if possible)
• Operating time of the device.
In case of disposal, please separate the different components according to their material consistency.
10.3 Software history
10.4
Contact addresses of Hauser
Contact address can be found on our homepage "www.endress.com/worldwide".
If you have any questions, please do not hesitate to contact your Hauser representative.
Software version / Date
Software changes
Documentation changes
V.1.82 / 09.1997
Original software
-
V.1.92 / 09.2002
Add density profile operation
BA003N/08/en/11.04
V 1.94 / 01.2005
Change graphic LCD
BA1003N/08/en/08.06
10 Troubleshooting
