Endress+Hauser Proline Promag H 500, Руководство по эксплуатации

Страница: 109 / 240

Proline Promag H 500 PROFIBUS DP Commissioning
Hauser 109
Parameter Prerequisite Description Selection Factory setting
Conductivity unit The On option is selected in
the Conductivity
measurement parameter
parameter.
Select conductivity unit.
Effect
The selected unit applies for:
Simulation process variable
Unit choose list µS/cm
Temperature unit – Select temperature unit.
Result
The selected unit applies for:
•
Temperature parameter
• Maximum value parameter
• Minimum value parameter
• External temperature
parameter
• Maximum value parameter
• Minimum value parameter
Unit choose list Country-specific:
• °C
• °F
Mass flow unit – Select mass flow unit.
Result
The selected unit applies for:
• Output
• Low flow cut off
• Simulation process variable
Unit choose list Country-specific:
• kg/h
• lb/min
Mass unit – Select mass unit. Unit choose list Country-specific:
• kg
• lb
Density unit – Select density unit.
Result
The selected unit applies for:
• Output
• Simulation process variable
Unit choose list Country-specific:
• kg/l
• lb/ft³
Corrected volume flow unit – Select corrected volume flow
unit.
Result
The selected unit applies for:
Corrected volume flow
parameter (→  149)
Unit choose list Country-specific:
• Nl/h
• Sft³/h
Corrected volume unit – Select corrected volume unit. Unit choose list Country-specific:
• Nm³
• Sft³
10.6.3 Configuring communication interface
The Communication submenu guides you systematically through all the parameters that
have to be configured for selecting and setting the communication interface.
Navigation
"Setup" menu → Communication
‣
Communication
Device address →  110