Endress+Hauser Micropilot NMR84, Руководство по эксплуатации

Страница: 65 / 256

Micropilot NMR84 Commissioning
Hauser 65
9.4.4 Configuration of a connected RTD
D
E
F
C
B
A
1
1
1
1 3
2
2 4
1
HR
CDI
WP
on
SIM
2
2
3
3
4
4
1 2 3 4 5 6 7 8
POWER
i
1 2 3 4 5 6 7 8
B
B1-3 B4-8
1 2 3 4 5 6 7 8
C
1 2 3 4 5 6 7 8
C1-3 C4-8
A0032465
 31 Possible locations of the Analog I/O modules, to which an RTD can be connected. The order code of the
device determines which of these modules is actually present →  18.
1. Make sure the RTD is connected as defined by the terminal assignment →  33.
2. Navigate to the submenu of the respective Analog I/O module: Setup → Advanced
setup → Input/output → Analog IP X4-8.
3. Go to the RTD type parameter (→  132) and specify the type of the connected
RTD.
4.
A
C
B
1 1 1 2 2 2 3 3 3 4 4 4 5 5 5 6 6 6 7 7 7 8 8 8
A0026371
 32 RTD connection types
A 4 wire RTD connection
B 3 wire RTD connection
C 2 wire RTD connection
Go to the RTD connection type parameter (→  133) and specify the type of
connection of the RTD (2-, 3- or 4-wire).
5. Go to the Input value parameter (→  135) and check whether the indicated
temperature matches the actual temperature.
6. Go to the Minimum probe temperature parameter (→  135) and specify the
minimum approved temperature of the connected RTD.
7. Go to the Maximum probe temperature parameter (→  136) and specify the
maximum approved temperature of the connected RTD.