Endorphines TWO OF CUPS, Инструкция по эксплуатации

Страница: 6 / 13

1.
1V/OCT PITCH CV
inputs is for the Pitch of the voices 1 and 2, which
follows 1v/oct scaling in range ­3...+3V (6 octaves), pitch voltage value is added to
the manual pitch offset selection knob (
RED mode). This lets you play the samples
melodically using a sequencer or a keyboard. You can adjust the v/oct scale in the
sd/settings/pitch_1(2).txt file on the SD card.
2.
VOICE 1/2 PARAMETER KNOB
set the values of the parameters in
each of six modes per voice (see MODES below).
3.
VOICE 1/2 TRIG
are trigger/gate inputs for voice 1 and 2 used to trigger the
samples, and since the internal envelope is an ASR envelope, you can vary the
length of the sample by adjusting the length of the Gate.
4.
SAMPLE 1/2 CV
are META CV inputs for the Voices 1 and 2. They accept
control voltage signals in the range of ­5V...+5V. If no CV is applied and no manual
sample offset selected using the Parameter knob, the first sample of each voice’s
folder is chosen. Sample select voltage value is added to the manual sample offset
selection knob (
FUCHSIA mode).
5.
VOICE 1/2 OUT
are 1 and 2 audio outputs over which samples are played. If
no cable is plugged into the Voice 2 audio output, both voices will be summed to
the output of Voice 1. When using stereo samples, only the left channel is played.
6.
MODE/BANK BUTTON
. Short button press switches thru six various
modes (see below) to be adjusted by VOICE 1/2 parameter knobs. Long press
switches to the next bank by blinking certain times with blue or red STATUS LED
(7). Super long press (around 5 seconds) will initiate nodule’s reset and folders
rescan.
7.
STATUS LED
shows currently selected mode and blinks showing currently
selected bank.
8.
VOICE 1/2 BUTTONS
are manual buttons to trigger the samples in each
voice as well as play with the fills* when the CLOCK IN* JACK (9) has a clock.
9.
CLOCK IN*
is a clock input on the front panel that adds Live Fill/Rolls
functionality. When there is a clock signal applied to the CLOCK IN* jack , the
buttons trigger rolls following the clock. Think of it as an alternative pattern that is
enabled by manually holding the trigger buttons for each channel.