Endless Pools X2000 SwimCross, Руководство пользователя

Страница: 31 / 36

Page 28
Service Information
GENERAL INFORMATION
Your SWIMCROSS exercise system has been designed to provide
years of trouble-free use. As with any appliance, problems may
occasionally occur that require the expertise of a qualified service
person. Though such simple repairs as resetting a GFCI switch or
breaker, or resetting a high limit thermostat may not require a service
call, they may indicate that a more serious condition exists. These
conditions may require an experienced service person. Before calling for
service, please refer to the Troubleshooting Guide. Always retain your
original sales receipt for future reference.
GFCI AND HIGH LIMIT THERMOSTAT
If your exercise system fails to operate at any time, first check the
power supply to the exercise system.
Check each of the GFCI breakers in the subpanel. If a GFCI has tripped,
reset it. If it will not reset, this may be an indication of a ground fault
(short circuit) within the electrical components. Contact an Authorized
Service Technician for a complete diagnosis.
If upon checking the GFCI’s you find that they have not tripped, check
the house breaker panel and ensure the main breaker for the electrical
circuit supplying the exercise system has not tripped. If it has, this is an
indication that the circuit was either overloaded or a ground fault exists
between the breaker panel and the exercise system receptacle or
subpanel. Contact a qualified electrician.
If upon checking the main house breaker and exercise system
GFCI’s you find no failures, check the high limit thermostat. To check
it, simply turn off power to the exercise system for 30 seconds. This
will automatically reset the high limit thermostat if it has tripped. If the
exercise system energizes once you turn the power back on, this
indicates reduced water flow through the heating system. Tripping of
the high limit thermostat is normally a result of one or a combination
of these problems. 1) clogged filter cartridge(s), 2) blockage within the
system plumbing, 3) a non-functioning heater circulation pump, 4) power
was not disconnected from the exercise system before it was drained,
5) an air lock in the plumbing lines. (The Power Indicator on the front of
the exercise system’s control panel will also be blinking if the high limit
thermostat circuit has tripped.)
If the exercise system does not function after tripping and resetting
the GFCI’s or resetting the high limit thermostat, then the problem
should be referred to an Authorized Service Technician. Refer to the
Troubleshooting Guide for additional service information.
MISCELLANEOUS SERVICE
INFORMATION
The control and high-limit thermostats are equipped with electronic
sensors that are connected to the exercise system’s plumbing. Never
cut or kink the wires that connect the sensors to the thermostats within
the control box.
The jet pump is equipped with a thermal overload cutoff switch that is
designed to protect the pump from overheating. If the pump shuts itself
off in an older exercise system, it could indicate failure of the pump
motor bearings. If the pump shuts itself off in a new exercise system, it
is usually the result of one or a combination of the following factors:
• Thermal overload: Although mass-produced, not all thermal overload
cutoffs are exactly the same. Some are more sensitive than others and
will shut the pump off at lower temperatures.
• High temperature: All
SWIMCROSS
exercise system models are
equipped with a jet pump shroud that vents the heat generated by the
pump motor to the outside of the equipment compartment, and back
into the exercise system water. If the vent is blocked by masonry,
grass or debris, overheating of the jet pump may occur. Once the pump
motor has cooled sufficiently and any blockage has been removed from
the vent opening, the jet pump can be restarted.
• Friction: Sometimes the moving parts of a new pump are tight enough
to cause heat build-up due to friction. After a normal break-in period,
the pump will run cooler.
• Improper wiring: If the exercise system is connected with an extension
cord, and/or the house wiring is undersized, the pump may starve
for voltage and therefore may draw more amperage and generate
excessive heat.
• If the pump is shutting down due to excessive heat, make sure the
equipment compartment has adequate ventilation. The air gap at the
bottom must not be blocked. Should your jet pump continue to shut off
after short periods of use, contact a qualified service technician.
ACTS INVALIDATING WARRANTY
The limited warranty is void if the SWIMCROSS exercise system has
been improperly installed, subjected to alteration, misuse, or abuse, or
if any repairs on the exercise system are attempted by anyone other
than an authorized representative of Watkins Wellness. Alteration shall
include any component or plumbing change, electrical conversion, or the
addition of any non-approved sanitation or water purification device or
heating system which contributes to component or unit failure or unsafe
operating system. Misuse and abuse shall include any operation of
the exercise system other than in accordance with Watkins Wellness
printed instructions, or use of the exercise system in an application
for which it is not designed; specifically: use of the exercise system
in a non-residential application; damage caused by operation* of the
exercise system at water temperatures outside the range of 2°C and
49°C (35°F and 120°F); damage caused by a dirty, clogged or calcified
filter cartridge; damage to the exercise system surface caused by
the use of tri-chloro chlorine, BCDMH, misuse of chemical tablets in
a floater, acid, or any other exercise system chemicals or exercise
system surface cleaners which are not recommended by Watkins
Wellness; damage caused by allowing undissolved exercise system
sanitizing chemicals to lie on the exercise system surface (no exercise
system surface material can withstand this kind of abuse); damage to
components or exercise system surface caused by improper water
chemistry maintenance; and damage to the exercise system surface
caused by leaving the exercise system uncovered while empty of water
and in direct exposure to sunlight (this may cause solar heating distress
in warm weather regions). These are considered abuses and may
invalidate this warranty.
*Operation of the exercise system does not mean “use” of the exercise
system! Watkins Wellness does not recommend using the exercise
system if the water temperature is above or below the exercise
system’s control panel temperature range.
Service Information