7. Load resin
12
7.1
When you wait for the temperature to rise, hang the filament over the filament rack.
7.2
Press the extrusion clamp and insert the filaments along the extruder hole up to the nozzle. When the temperaturehits the target value, a flow of filaments can be seen at the nozzle,
meaning that the filaments have been loaded.
For smoother printing, the end of
the filament should be cut as
shown above.
Replacement of filaments:
1. When the printer is not under work:
A.
Heat the nozzle to above 185°C first, wait for the filaments inside the nozzle to soften,
then press the extrusion handle and pull out the filaments quickly to prevent them from
getting stuck at the heat break;
B.
Replace the new filaments onto the material rack and repeat the loading procedure in 7.
2. When the printer is working:
A.
Suspend printing first and, once the printer has stopped, press the extrusion handle to pull
the filaments out quickly and prevent them from getting stuck at the heat break;
B.
Replace the new filaments onto the material rack, press the extrusion handle, insert the
filaments through the extruder feed hole into the nozzle, then push the filaments hard to
squeeze out the residual filaments from the nozzle, and clean it up for printing.
