Go to “Prepare → Disable stepper" to switch off all motor enables.
6.5
11
The nozzle is too far away from the platform, so the
filaments can not adhere to the platform.
The nozzle is too close to the platform, leading to
insuficient filament extrusion, even scraping the platform.
Filaments are extruded evenly, just sticking on the platform.
Adjust the knob at the bottom of the hotbed and move the nozzle to the four corners of the printing platform, respectively, so that the height of the nozzle to the
printing platform is approximately the thickness of A4 paper (0.08-0.1mm). Make sure that the four corners are properly leveled.
6.6
6. Auxiliary levelling
0.00
Leveling
