Endeavour Tools ET8636, Инструкция по эксплуатации

Страница: 20 / 44

18
MEASUREMENT PROCEDURES
※
Operating instructions are displayed in the last page of the test result.
Press (ENTER) Key
：
Enter Battery System Test
Press (MENU) Key
：
Move to Menu screen (Print / Save Data / Delete Save Data)
(Page 23)
※
Make sure to input Industrial Rating when testing battery condition (good / bad) of
industrial battery.
※
In case of the test result of the Battery Test is "Replace (Cell Defect)", charge battery
fully, and test it again and judge with observing a state of the battery.
※
For the vehicle equipped with higher grade battery, start performance of engine may
have no problem even if the judgment result is "Replace". In this case, battery
replacement is recommended to prevent suddenly battery breakdown.
The battery which is not charged for a long term may be judged "Replace" due to
decreasing CCA by self-discharge even if it is a new battery. Keep the battery with
periodical auxiliary charge to prevent deterioration by leaving with exhausted
condition for a long term.
MENU
⑨
When battery test is completed, the test
result screen is displayed as shown in the
right. Confirm test result with using
△
(UP
SCROLL) /
▽
(DOWN SCROLL) Keys .
LED indicator lights up or flashes depending
on a test result as follows.
・
Green LED lights up when the test result is
"Good"
・
Green & Yellow LED lights up when the
battery is fine but needs re-charging
・
Yellow LED lights up when the test result
is "Charge/Retest"
・
Yellow LED flashes when the test result is
"Caution"
BAD GOOD CHARGE
Green LED lights up when
test result is "Good"
[ BATTERY TEST ]
Good
JIS
55B24
370 CCA
※
The following results are displayed.
・
Battery test result
・
Model (JIS only)
・
Selected battery type
・
SOH (State of Health)
・
CCA value (Standard m
Ω
for Industry)
・
Measured CCA (measured m
Ω
for Industry)
・
Temperature
・
SOC (State of Charge)
・
Battery voltage
・
Testing method
・
Testing Mode
・
Comment
・
Red LED lights up when battery test result is "Replace"