page 2 of 2
Rev. A
USING SPEAkERS wITHOUT BRACkETS
(BOOkSHELF CONFIGURATION /
not available w/ IO-510
)
This cabinet speaker may be set on a bookshelf, desktop,
stand, or other flat surface. The speakers are shipped
with additional solid endcaps that provide a finer look
when the U-Brackets are not used.
1.
Remove the endcaps by pulling the back
end of them away from the enclosure.
2.
Loosen and remove the brass thumb screws
that hold the bracket to the speaker.
3.
Remove the bracket and replace the thumbscrews.
Tighten them securely with your fingers.
4.
Slip the front edge of the solid endcaps into the
available grooves and press the endcaps into place
ensuring that they engage with the thumbscrews.
5.
Install the supplied vinyl feet to the bottom of
the speaker by peeling them from the sheet
and pressing them into place. They may also be
attached to the side of the speaker if one intends to
lay the speaker on its side.
INSTALLATION
(
USING OPTIONAL DOUBLE SwIvEL BRACkET)
Follow the manufacturers
instructions for the installation of
the bracket. To prepare the speaker
for this type of bracket, remove the
supplied bracket and replace the
endcaps following steps 1-4 in the
previous section, “Using Speakers
without Brackets.” The bracket is
attached to the back of the speaker
using ¼-20 screws or bolts. The
length of the hardware will be
determined by the bracket thickness but it will likely
be about 1/2” to 5/8” in length. It will be necessary to
remove the terminal cover from back of the speaker. To
do this, use your finger(s) to pull back on the bottom of
the cover at the relief in the enclosure.
INSTALLATION
1.
Determine the installation location of the speaker.
Use care to ensure the structure has the ability to
carry the weight of the speaker. We recommend
that the speaker be located where there is a stud or
other support structure especially if the speaker will
be oriented horizontally. If attaching to sheetrock
(gypsum board), ensure that you use suitable
hardware such as toggle anchors (not supplied).
2.
Measure the hole-spacing on the bracket and
transfer these dimensions to the mounting surface.
3.
Install the attachment hardware, drilling holes as
necessary.
In most installations the bracket will need to
be removed from the speaker so that it can
be tightened to the mounting surface without
obstruction.
4.
Remove the endcaps by pulling the back end of them
away from the enclosure.
5.
Remove the bracket from the speaker by loosening
and removing the brass thumb screws that hold the
bracket to the speaker.
6.
Screw the bracket to the mounting surface. Either
set of holes may be used (slots or keyholes). If
the wire is coming through the wall then it can be
passed through the center-hole in the bracket if
desired or practical.
7.
Prepare the wire for termination by stripping back
the insulation approximately
½” (13mm).
8.
Remove the terminal cover from back of the speaker
using your finger(s) to pull back on the bottom of the
cover at the relief in the enclosure.
9.
Attach the speaker to the bracket making the thumb
screws finger tight.
10.
Position the speaker so the input terminals can be
accessed.
11.
Pass the wire through the cover and connect it to
the input terminals, observing polarity to ensure
consistency.
12.
Snap the terminal cover into place and rotate the
speaker in the desired direction.
13.
Tighten the thumb
screws. A screwdriver
may be used to ensure
they are tight.
14.
Re-install the endcaps.
page 2 of 2
Rev. A
notched end cap - top
solid end cap - bottom
Indoor / Outdoor
5-1/4", 6-1/2", 8"
Cabinet Loudspeaker
