Endace DAG 6.1S, Руководство пользователя

Страница: 15 / 44

EDM 01-11v8 DAG 6.1S Card User Guide
©2005 10 Version 8: May 2006
4.1 Interpreting DAG 6.1S Card LED Status
, continued
LED definitions The following table describes the LED definitions.
LED Description
LED 1
RX FPGA successfully programmed.
LED 2 LOS: Loss of Signal; no valid optical signal seen by
receiver.
LED 3 Reserved.
LED 4 Reserved.
LED 5 PCI-X FPGA successfully programmed
LED 6 Data capture in progress.
LED 7 Ethernet mode; OFF for PoS.
LED 8 Reserved.
LED 9 PPS Out: Pulse Per Second Out; indicates card is sending a
clock synchronization signal
LED 10 PPS In: Pulse Per Second In; indicates card is receiving an
external clock synchronization signal
The LED’s labelled ‘Reserved’ may be in the ON or OFF state under
varying circumstances and can be ignored.
4.2 DAG 6.1S Card LED Display Functions
Description When a DAG 6.1S card is powered up the blue coloured LED 5 should
always come on, and the remaining LED's such as green and yellow
display for specific functions.
Figure
Figure 4-2 shows the correct LED state for DAG 6.1S card without optical
input.
Figure 4-2. LED State for DAG 6.1S Card Without Optical Input.