![background image](http://html.mh-extra.com/html/encore/e-4/e-4_installation-manual_2406090006.webp)
E4 IN REV. A
6
-
Special considerations must be made for windshield glass as some newer vehicles utilize a
metal-shielded window glass that will inhibit or restrict RF reception. In these vehicles, route the two ways
transceiver/antenna module away from metallic shielded window glass as far as possible.
2 PIN BLUE CONNECTOR FOR THE VALET SWITCH:
Select a mounting location for the switch that is easily accessible to the driver of the vehicle. The switch
does not have to be concealed, however, concealing the switch is always recommended, as this
provides an even higher level of security to the vehicle. Mount the valet switch in a hidden but
accessible location. Route the valet switch wires to the control module.
4 PIN ORANGE CONNECTOR 2 STAGE SHOCK SENSOR (ZONE 1 / 4)
1
.
Green
Wire /
Zone 1
Warn Away Input
2. Blue
Wire /
Zone 4
Ground Trigger
3. Black
Wire / Ground
4. Red
Wire / +12Volts
10 Pin, Main Connector
Pin #
Wire Color
Specification
1
White
(-) Dome Light Output
2
Gray
Channel 3Trunk Output (-)
3
White / Blue
Channel 4 (-) Aux Output
4
Pink
2 Step Unlock Output
5
Orange
Ground Output (-) when armed
6
Green
Negative (-) Door Trigger
7
Yellow
Ignition: 12 Volt (+) with key ON
8
Violet
Positive (+) Door Trigger
9
Black / Blue
Channel 5 Programmable Output (-)
10
Blue
Zone 2, (-) Hood / Trunk Trigger
White wire
– (-) 200mA Dome Light Control Output –
This wire becomes grounded when the
dome light controls circuit active. The
current capacity of this wire is 200mA.
This wire can control the operation of
the interior lights. An optional 10 Amps
relay can be used to this system for
interior lights operation.
87a
86
87
30
85
Fuse
White
Wire
+12V
Door
Switch
Courtesy
Light
a). Upon disarming, the interior lights will remain on for 30 seconds.
b). If the alarm is triggered, the interior light will flash for the same duration as the siren.
Содержание E-4
Страница 3: ...E4 IN REV A 3 INSTALLATION DIAGRAM ...