Encore E-4, Руководство по установке

Страница: 12 / 14

E4 IN REV. A 12
ALARM FEATURE “C” PRORAMMING:
1 Turn the Ignition 'switch
‘ON/OFF’ 3 TIMES
and stay in OFF position .
2 Push the Valet switch 5times (holding in on the 5th push ) until one long chirp is heard then release the valet
switch. You are now in the Alarm feature
“C”
programming mode.
3 Press and release the transmitter button corresponding to the feature you want to program.
Press
Transmitter
Button
One Chirp / LED
one pulse
Factory Default
Setting
Two Chirps / LED
two pulses
Three Chirps /
LED three pulses
Four Chirps / LED
four pulses
1
Channel 3 Output
=
2 sec. Pulse
Channel 3 Output
=
Latched
Channel 3 Output
=
Timer control
Pager Output
2
Channel 5
Output =
2 sec. Pulse
Channel 5 Output
=
Latched
Channel 5 Output
=
Timer control
Pager Output
3
Pink Wire =
2 Step Unlock
Pink Wire =
Factory Disarm
4
Channel 4 Output
=
2 sec. Pulse
Channel 4
Output =
Latched
Channel 4 Output
=
Timer control
Pager Output
Exit: Turn Ignition to 'ON' position, or leave it for 15 seconds. 3 long chirps & 3 parking light flashes will confirm exit.
Channel 3/4/5 Timer Control Output Programming:
Enter:
1.
Turn the Ignition 'switch ‘ON/OFF’ 5 TIMES and stay in OFF position.
2. Push the Valet switch 5 times and hold in on the 5
th
push, when a long chirp is heard, then release the
valet switch. You are now in the Alarm feature
‘C’
programming mode.
Timer Program Channel 3/4/5:
1-a. CH 3 Press and release the transmitter button 3 times, [3] LED flash, [3] siren/horn chirp to
indi
cate you are in features “Channel 3 Timer Programming mode”.
1-b. CH 4 Press and release the transmitter button 3 times, [3] LED flash, [3] siren/horn chirp to
indicate you are in features “Channel 4 Timer Programming mode”.
1-c. CH 5 Press and release the transmitter button 4 times, [3] LED flash, [3] siren/horn chirp to
indicate you are in features “Channel 5 Timer Programming mode”.
2. Press and hold the valet switch, the timer will immediately start.
3. When the desired interval has passed, release the valet switch. 1 long chirp for confirmation.
(Set to any interval between 1 second and 2 minutes)
Note 1 :
If your built-in timer controls window/sunroof closure in your car DO NOT change the timer setting! This
requires installer-only programming. Changing the value will adversely affect operation and may cause
damage.
Note 2:
Latched output
= The latched output selection will send a negative signal as soon as the Channel 3/4/5
button is pressed and will continue until the button is pressed again.