Encore Networks BANDIT II C2C, Руководство пользователя

Страница: 5 / 8

Using a Three-Pronged DC Power Connector with a BANDIT II C2C
Page 5
Figure 3-7. Top Section of Shell above Cabled Three-Pronged
DC Power Connector and Bottom Section
c
Make sure the DC power connector sits properly in the bottom section. Then snap the
top and bottom sections together, as shown in
Figure 3-8 .
Note: Make sure the cables go through the cable hole.
Figure 3-8. Closed Three-Pronged DC Shell Assembly
Note: If you need to take the case apart, grasp each flange of the top section and gently
pull them away from the latches on the bottom section. Then pull the top section off
the bottom section. Repeat Step 10
a through Step 10 c to reassemble the connector case.
11
When the shell assembly has snapped into place around the DC plug, do the following:
a Flanges on the plug ( Figure 3-9 ) allow it to fit into the three-pronged DC power input
port on the backplate of the BANDIT chassis in only one way.
Module TOC