Encore Networks BANDIT II C2C, Руководство пользователя

Страница: 6 / 8

Page 6
BANDIT II C2C Module, Document 3
Note: To review the orientation of the three-pronged DC power input port, see the
following:
• Figure A-2 or Figure A-3 in Section A.1, The BANDIT II C2C Chassis , in the BANDIT II
C2C Hardware Description and Specifications ).
You may need to turn the plug over to fit it into the port. If this is the case, rotate the
shell assembly 180
°
around the axis corresponding to the DC power cable ( Figure 3-9
and Figure 3-10 ).
Figure 3-9. Rotate Three-Pronged DC Shell Assembly 180 Degrees
around Axis of Power Cable
Figure 3-10. Three-Pronged DC Shell Assembly Rotated 180 Degrees
b Plug the DC power connector (the shell plug) into the DC power input port on the rear
of the BANDIT chassis.
c Then connect the other end of the DC power cable to a -24/-48 volt DC or -12/-24 volt
DC power source.
Note: The power source must supply -12/-24 VDC or -24/-48 VDC.
Caution:
The DC power source must match the DC input power rating indicated on
the BANDIT chassis.
❖
The BANDIT chassis powers up.
12 If the BANDIT chassis will use AC input power (instead of DC power or in addition to
DC power), connect the AC power supply to the chassis, and then connect the AC
power supply to a power outlet supplying 100–240 VAC at 47–63 Hz.
❖
The BANDIT chassis powers up.
!
Module TOC