EMX WEL-200R, Руководство по эксплуатации

Страница: 3 / 20

WEL-
200™ Operating Instructions
2
Document no.
10320104 Revision 2.0 3-1-19
All rights reserved. Unless otherwise stated, the material within this document is copyright of EMX
Industries Inc. No part may be reproduced, in whole or in part, without the specific written
permission of EMX Industries Inc.
Refer servicing to qualified service personnel.
IMPORTANT:
This product is an accessory or part of a system. Always read and follow the manufacturer’s
instructions for the equipment before connecting this product. Comply with all applicable codes
and safety regulations. Failure to do so may result in damage, injury or death.
FCC ID: 0A3MRF89XAM9A
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
UL File: E315703
The WEL-200 is designed for use with Entrapment Protection Type
B2 devices per the 2018 UL325 standard. This system meets the
UL325 requirements for N.C., 10K resistive, 4-wire pulsed
monitoring methods.
Copyright Notice
Cautions and Warnings
1. Read and follow all operating and Installation instructions.
2. Always follow gate operator manufacturer installation instructions regarding installation
of type B2 devices to the operator.
3. Disable the gate so it is unable to move.
The WEL transmitter is designed for connection to a single
edge.
NEVER CONNECT MORE THAN ONE EDGE TO A SINGLE
TRANSMITTER!
When multiple edges are required, connect each edge to a
separate WEL transmitter for safe operation.
Regulatory Information