Softsynchro
®
6
Operating instruction edition: 01.04.2018 7
2 Putting the quick-change tap holders into operation
2.1 Unpacking
Take the quick-change tap holder from the packing
Clean the quick-change tap holder with a duster to remove any conservation
oil
Note
Do not use any aggressive solvents.
Do not use fibrous materials i.e. steel wool.
The quick-change tap holder is now ready for operation.
Exception:
Type with
hollow taper shank (HSK)
. Please refer to chapter 2.4.1 page 9, for how
to put this quick-change tap holder into operation.
2.2 First putting into operation
Note
For quick-change tap holders with HSK-shank (hollow taper shank) the coolant-
lubricant tube must be mounted prior to putting into operation, see chapter 2.2.1,
page 8
When working with internal coolant supply:
The tap holders are made for coolant pressures up to
50 bar
Attention
The exchange of the tool must not be executed while the machine spindle rotates!
Only use tool shanks suitable for the specific machine.
Make sure the tool is correctly clamped.
Otherwise: Risk of accident by spinning of the tool!
Please see also the indications in the operating instruction of your machine tool!
√
