- tap and hold inside the selection for the fine regulation of the loop
- double tap inside the selection to select again the whole file
When a loop is set, deselect the (tap again
#
) to zoom-in into the loop
selection.
$
Reset scanning to the start position.
%
Waveform Scrubbing Mode, when selected the pointer jumps to the
Absolute
position of the finger that touches the waveform. If unselected (
Relative)
it
does not jump but the scrubbing occurs from Sampler position toward finger
touch.
From left to right:
1) Reset to beginning both samplers
2) Synchronise the sampler Ch. 2 phase according to sampler Ch. 1
3) Load an audio sample, see Samples Manager for mode details.
If you are loading a stereo sample, you can chose the input channel: left/right
or 50% mix of both channels.
It’s possible trigger the ‘reset scanning’ from DK or the Sequencer.
Finally you can link the Ratio of Sampler Ch.2 with the Sampler Ch1 (lock
icon), in this mode you can feed iVCS3 with stereo files and keep the
scanning ratio synchronised.
N.B. You can disable the Crossfade and change Waveform style from
the Settings.
See the Settings for more details.
FX
Just outside of the Master Output (Matrix Columns B and C) this
Flanger/Delay effect can be toggled in three positions: Off, Flanger and
Delay,
FLANGER
: The
‘
lfo’
(i.e. Low Frequency Modulation) and
‘d’
(i.e.
Delay)
knobs adjust the frequency and amplitude of the controlling
oscillator. Increasing the amount of feedback, with the
‘g’
(i.e. Gain or
Feedback) knob will produce more metallic timbres by reinforcing and
Содержание iVCS3
Страница 5: ......
