EMS 110-SPMECG6-10A, Инструкция по установке и наладке, Страница: 11 / 20

Single Phase Motor Energy Control - Page 11 of 20
4.1.1 4A AND 10A PCB CONNECTOR IDENTIFICATION
TERMINAL LOCATION FUNCTION
L
PCB Supply Input Positive
L
PCB Supply Input Positive Auxiliary
N
PCB Supply Input Neutral
N
PCB Supply Input Neutral Auxiliary
E
PCB Supply Input Earth
E
PCB Supply Input Earth Auxiliary
MOTOR L
PCB Motor Feed Positive
MOTOR N
PCB Motor Feed Neutral
MOTOR E
PCB Motor Feed Earth
4.1.2 25A CONNECTOR IDENTIFICATION
TERMINAL LOCATION FUNCTION
Input L
Base Plate Connector Supply Input Live
Input N
Base Plate Connector Supply Input Neutral
Motor L
Base Plate Connector Motor Feed Live
Motor N
Base Plate Connector Motor Feed Neutral
Earth
Base Plate Connector Earth
4.2 SETTING UP
All EnviroStart DIP Switches are polled continuously and it should be possible to make
changes whilst the unit is running to change between operational modes. It is however good
practice to make changes whilst the unit is switched off to ensure that the software is not
“hung” or “corrupted” as a result of a spike being transmitted to the chip during “live”
switching.
ADJUSTMENT FUNCTION
DEFAULT
SETTING
RESULT SEE SECTION
Switch 1
Energy Saving
Mode Select
OFF
Energy Savings
Enabled
4.3.3
Switch 2
Auto – Manual
Savings Select
OFF Automatic 4.3.3
Switch 3 & 4
Energy Saving
Level
ON OFF
Level 2 Energy
Savings
4.3.3
Switch 5 Soft Start OFF Soft Start Disabled 4.3.4
Switch 6
Two Minute Time
Delay
OFF Time Not Enabled 4.3.5