3
INSTALLATION
Host Interface Connections
Most current motherboard models have two IDE ports (primary and secondary),
which can connect two IDE cables. Two IDE cables allow you to connect up to
four devices, but it is recommended that you separate IDE ports for your hard
disk and your Dual Digital Storage Drive. This will ensure that your hard disk’s
performance and speed won’t be affected by having the drive on the same
cable.
Jumper Setting
On the rear panel of this drive, you will find three pairs of jumpers: CS (CSEL),
SL (Slave) and MA (Master). Use the jumper cap to set the device to CS, SL or
MA mode corresponding to your PC configuration. If you connect only one
device on the IDE cable, you can set the jumper as “MASTER” or “SLAVE”.
Cable Select
Slave
Master
If you connect two devices on the same cable, set different jumper for each
device (one as “MASTER”, and the other one as “SLAVE”). The same rule
applies to the connection of having your hard disk and another device on the
same cable.
