Empress Effects ParaEq MKII, Руководство пользователя

Страница: 8 / 16

low freq, mid freq, high freq:
Selects the center frequencies
around which you’d like to boost or
cut for each band.
bypass stompswitch: When the LED
is shining, the ParaEq MKII effect is
applied to the signal. When off, the
effect is being bypassed (true and
buffered bypass available. See
advanced configuration).
low q, mid q, high q: The q
switches determine the range of
frequencies affected by the
equalizer on each band.
Wide q ( ) will affect a wide
range of frequencies around the
selected frequency. q ≈ 1 affects
about 1.5 octaves
Medium q ( ) will affect some
frequencies around the selected
frequency. This is a good place to
start for overall tone shaping. q ≈
2.5 affects about 2/3 octave
Narrow q ( ) will only affect a very
narrow range of frequencies around
the selected frequency. q ≈ 4
affects about 1/3 octave
There is a q control for each of the
three frequency bands available on
the ParaEq MKII.
gain: Determines the amount of
boost or cut applied to frequency
band. At the 12:00 setting, there is
no boost or cut applied. The range
of boost or cut available for each
frequency band is -15dB to +15dB.
Controls at a Glance
boost: Controls the output level. It
is a clean boost, perfect for
providing gain before an effects
chain to minimize noise or to
overdrive the input of a tube amp.
The available boost ranges from 0
dB to +30 dB and is toggled on/off
with the boost stompswitch.
boost stompswitch: Toggles on/off the boost section of the unit. When the
LED is shining, the boost is applied to the signal.