Empire VFIL18N, Инструкция по установке и руководство пользователя

Страница: 13 / 40

26532-2-0410 Page 13
• Turn off the gas supply to the fireplace or firebox.
• Seal any fresh air vents and/or ash clean-out doors located on
the floor or wall of the fireplace. If left unsealed, drafting may
cause pilot outage or sooting. Use a heat resistant sealant. Do
not seal the chimney flue damper.
Before installing in a solid fuel burning fireplace, the chimney flue
and firebox must be cleaned of soot, creosote, ashes and loose paint
by a qualified chimney cleaner.
You must secure the gas appliance to the fireplace floor.
If not, the entire unit may move when you adjust the
controls. Movement of unit may cause shifting of the
optional decorative glass. Burner movement could cause
a gas leak.
Special care is required if you are installing the unit into a
sunken fireplace. You must raise the fireplace floor to allow
access to gas controls. This will insure adequate air flow
and guard against sooting. Raise the fireplace floor using
noncombustible materials.
Installation of Burner Support Legs
Four (4) Burner Support Legs are included with the Loft Burner.
Installation is optional if you have a VFRL (millivolt series
burner.
• If a Remote Control option is to be used with the VFRL
(millivolt) series burner without the Support Legs installed,
the remote receiver box must be installed outside of the
firebox away from excessive heat. However, the remote
receiver may be placed under the elevated Loft Burner by
installing the (4) Burner Support Legs. See Figure 10.
If the Support Legs are to be installed, simply bend each
of the (4) legs into a "U" shape to match the drawing in
Figure 11. Next, install the legs into the bottom base. Line up
the three tabs on each leg with the slots provided, using pliers
twist each of the tabs slightly in order to secure the legs to the
bottom base.
• Installation of the Burner Support Legs is necessary on the
VFIL (remote ignition) series burners. These models include
a remote receiver box that must be placed under the bottom
base of the Loft Burner assembly to shield the receiver
batteries from excessive heat. See Figure 17.
To install the Support Legs, simply bend each of the (4) legs
into a "U" shape to match the drawing in Figure 11. Next, install
the legs into the bottom base. Line up the three tabs on each
leg with the slots provided, using pliers, twist each of the tabs
slightly to secure the legs to the bottom base. See Figure 10.
Figure 10
Figure 11
BEFORE FULLY INSTALLING THE APPLIANCE