27440-1-0510
Page 14
Before you begin: if you are installing logs onto the VFD(R,T,M)18
or VFD(R,T,M)24 models, this burner assembly is supplied with a
set of five ceramic fiber logs. Do not handle these logs with your
bare hands! Always wear gloves to prevent skin irritation from
ceramic fibers. After handling logs, wash your hands gently with
soap and water to remove any traces of fibers.
The positioning of the logs is critical to the safe and clean operation
of this burner assembly. Sooting and other problems may result
if the logs are not properly and firmly positioned on the burner
assembly. Refer to
figure 13
and
figure 14
and corresponding
wArNING:
when completing following log placement instruc-
tions.
1. Place Front Left Log (B) on left front side of burner. Align
notch on log with front of burner support bracket.
2. Place Middle Log (C) behind B log on burner. Align notch
on log with back of the burner support bracket.
3. Place Rear Log (D) on rear log support. Align notch on bot-
tom left of log with the rear burner support bracket.
4. Place Front Right Log (A) on right front of burner.
5. Place Right Branch (F) in grooves between Front Left Log
(B), Middle Log (C), and Right Front Log (A).
6. Place Left Branch (E) in grooves on Rear Log (D) and
Middle Log (C).
eMBeR MaTeRIaL PLaceMenT on BuRneR
7. After all logs are positioned properly, apply Rockwool ember
material to the front burner port area. To apply, carefully
separate the ember material into small amounts no larger than
"dime size" pieces. Fluffed up pieces one layer thick on top
of the burner generally works best, and will provide the best
ember glow. Do not place ember material more than one layer
thick. No more than (2) two small packets of ember material
(part no. 15998) evenly placed on the burner, is recommended
on VFDR18 and VFDR24 models. Using additional ember
material will decrease the amount of ember glow effect. Extra
ember material should be saved for future ember applications
as necessary.
figure 13
wArNING:
Failure to position the parts in accordance with
this diagram or failure to use only parts specifically approved
with this appliance may result in property damage or personal
injury.
Attention:
Do not use Figure 13 or Figure 14 to order logs. Refer
to Parts Lists and Parts Views to order logs and/or ember material
for your appropriate model.
figure 14
Vfd(R,T,M)(18,24,30) & VfdR18LBW10 LoG PLaceMenT
Description
Part #
VFD(R,T,M)18 Embers 15998
VFD(R,T,M)24 Embers 15998
VFD(R,T,M)30 Embers 15999
Platinum Bright Embers PE20-1
Note: A single layer of embers is to be used when applying
Platinum Bright Embers (alone or in combination with standard
embers) to the burner.
A
B
C
D
E
F
EMBER MA
PLACEMENT
(SHADED AREA ONLY)
TERIAL
figure 12
A
B
C
D
E
F
