26989-3-0510
Page 5
Important
All correspondence should refer to complete Model Number, Serial
Number and type of gas.
Attention: during initial use of log you will detect an odor as
the log is cured.
Notice:
During initial firing of this unit, its paint will bake out, and
smoke will occur. To prevent triggering of smoke alarms, ventilate
the room in which the unit is installed.
wArNING
: This appliance is for installation only in a solid-
fuel burning masonry or
UL 127
factory-built fireplace or in a
listed ventless firebox enclosure. It has been design certified for
these installations. exception: do NoT install this appliance
in a factory-built fireplace that includes instructions stating
it has not been tested or should not be used with unvented
gas logs.
WARNING: Any modification to this unvented gas heater or
its controls can be dangerous. Improper installation or use of
the heater can cause serious injury or death from fire, burns,
explosion or carbon monoxide poisoning.
Well Head Gas Installations
Some natural gas utilities use "well head" gas. This may affect the
Btu output of the unit. Contact the gas company for the heating
value. Contact the manufacturer or your gas company before
changing spud/orifice size.
IMPoRTANT: Read all instructions carefully before starting
installation. failure to follow these installation instructions may
result in a possible fire hazard and will void the warranty.
Save this manual for future reference.
Please read this manual before installing and using the
appliance.
Instructions to Installer
1. Installer must leave instruction manual with owner after
installation.
2. Installer must have owner fill out and mail warranty card supplied
with unvented room heater/vented decorative appliance.
3. Installer should show owner how to start and operate unvented
room heater/vented decorative appliance.
Always consult your local Building Department regarding
regulations, codes or ordinances which apply to the installation of
an unvented room heater/vented decorative appliance.
This appliance may be installed in an aftermarket* manufactured
(mobile) home, where not prohibited by state or local codes.
*Aftermarket: Completion of sale, not for purpose of resale, from
the manufacturer.
This appliance is only for use with the type of gas indicated on the
rating plate. This appliance is not convertible for use with other
gases.
Any alteration of the original design, installed other than as
shown in these instructions or use with a type of gas not shown on
the rating plate is the responsibility of the person and company
making the change.
PRoducT SPecIfIcATIoNS
AcceSSOrIeS
Description
Color
for use with VfSe models
EK-1
Embers Kit
ELH-1
Fireplace Hood for Vent-Free Logs
Black
ELH-2
Fireplace Hood for Vent-Free Logs
Brass
AD-110-6V AC/DC Adapter
INTrODucTION
Model
Gas
Valve Type
BTuH
Max. Rate
BTuH
Med. Rate
BTuH
Min. Rate
VFSE-18
Natural
Intermittant
32,000
—
26,000
VFSE-18
Propane
Intermittant
32,000
—
26,000
VFSE-24
Natural
Intermittant
36,000
—
28,800
VFSE-24
Propane
Intermittant
36,000
—
28,800
VFSE-30
Natural
Intermittant
38,000
—
30,000
VFSE-30
Propane
Intermittant
38,000
—
30,000
Natural Gas
Propane Gas
Regulator pressure setting
4.0" W.C.
10.0" W.C.
Gas inlet pressure
Max.
10.5" W.C.
13.0" W.C.
Min.
3.5" W.C.
11.0" W.C.
