29829-19-1017
Page 24
Before you begin: Do not, handle these logs with your bare hands!
Always wear gloves to prevent skin irritation. After handling logs,
wash your hands gently with soap and water.
All Logs
The positioning of the logs is critical to the safe and clean operation
of this heater. Sooting and other problems may result if the logs are
not properly and firmly positioned in the appliance.
WARNING:
Failure to position the parts in accordance with this
diagram or failure to use only parts specifically approved with
this appliance may result in property damage or personal injury.
PROPER INSTALLATION SEQUENCE
:
(Figure 26)
1. Place back (#1) log between rear log support and burner pan.
2. Place left, front log (#2) onto two (2) left, front pins on burner
pan.
3. Place right, front log (#3) onto two (2) right, front pins on burner
pan.
4. Compare the completed log installation with the appropriate
photo from page 47. Review previous steps to make any
necessary adjustments.
5. Log placement is completed.
6. Attach log placement plate to cable holding lighting instructions
for future reference.
Attention:
Do not use
Figure 26
to order replacement logs. Refer to
Page 46 Parts List and Parts View to order logs for your appropriate
model number.
Apply loose material (glowing embers) per appropriate Installation
Instructions and Owner's Manual. Replacement of loose material
(glowing embers) must be purchased from an authorized distributor.
Application of excess loose material (glowing embers) may
adversely affect performance of the heater.
Rock wool can be added to burners for a glowing ember effect.
Apply loose material (glowing embers) only on locations shown on
Page 25. Replacement of loose material (glowing embers) must be
purchased from Empire Comfort Systems, Inc. Application of excess
loose material (glowing embers) may adversely affect performance
of the heater.
WARNING:
All previously applied loose material must be
removed prior to reapplication.
Replacement Loose Material (glowing embers)
Part Number: 15998
NOTICE:
A single layer of embers is to be used when applying
Platinum Bright Embers (alone or in combination with production
embers) to the burner.
Log Placement
Figure 26
The following WARNING applies when log set is installed onto an
unvented gas burner assembly.
WARNING:
This appliance is equipped for (natural or propane)
gas. Field conversion is not permitted.
2
1
3
VFP20IN LOG PLACEMENT