7
6. Press and hold the On button
on the manual controls
(Figure 6-A) for five (5)
seconds. The Level 1
Indicator Light (Figure 6-D)
will then flash for 10 seconds.
7. Within
the 10 seconds
press the ON button located
on the remote control
transmitter. (Figure 7) This
will synchronize the remote
control transmitter and
receiver.
Remote Control
The remote control has a range
of approximately 50ft. (15.25m)
(Figure 7). It does not have to
be pointed at the fireplace and
can pass through most obstacles
(including walls). It is supplied
with one of 2, 187 independent
frequencies, in the factory, to
prevent interference with other
units.
Remote Control Initialization/
Reprogramming
Follow these steps for remote
control initialization and if
required, re-initialization:
1. Ensure that power is supplied
through main service panel.
2. Access the manual controls,
(remove the glass doors if
applicable) pull the right hand
steel curtain to the outside of
the unit. (Figure 5)
3. Locate manual controls.
4. Move the 3-way switch to
“Remote”.
5. Activate the main power
switch, the red Level 1
Indicator Light will flash
.
(Figure 6-D)
Operation
Figure 6
A
B
C
D E F
