B102218-6-0119
Page 38
Although we have attempted to ensure that your grill will operate properly and satisfactorily, sometimes problems do arise.
The following troubleshooting guide lists several possible problems and their probable cause and solution.
Do not repair or replace any part of the grill unless specifically recommended in this manual.
All other service should be referred to a qualified technician.
Problem
Cause
Solution
Burner will not light.
Spider webs in venturi tubes
Clean venturi tubes. See Maintenance Section.
Out of gas
Refill LP gas cylinder. If natural model, turn on
gas at source.
Gas injector not inserted in
venturi tube
Realign/engage gas injector with the venturi
tube.
Clogged gas injector
Remove gas injector from gas control assembly
and clean.
Obstruction in gas line
For propane models, ensure gas valve on cylin-
der is OFF. Remove flexible hose and blow out
any debris.
Misalignment of collector box
and burner
Position electrode properly. Clean collector box.
Dead battery
Replace with AA Alkaline battery.
Inadequate grill temperature.
Poor combustion
Adjust air shutter.
Misalignment of venturi tube
and gas injector
Realign/engage gas injector with the venturi
tube.
Inadequate gas pressure
Contact gas supplier for assistance.
Flames off the burner.
Cold grill
Preheat grill at least 5 minutes on HI with the
grill lid open.
Misalignment of burner tube
and gas injector
Realign/engage gas injector with the burner
tube.
Poor combustion
Adjust air shutter.
Extreme wind
Turn or shield grill.
Yellow flames.
Air shutter improperly set
Open air shutter.
Spider webs in venturi tubes
Clean venturi tubes. See Maintenance Section.
Seasoning salts on burner
Clean by washing burner with mild detergent.
Oil film on burner
Allow burner to operate on HI for 10-15 minutes.
Low heat with knob in "High" position.
Check for proper gas supply and pressure.
Pre-heat grill for a full 15 minutes.
If using L.P. gas, check for empty tank.
Check for kinks in supply line.
If only one burner appears low, clean burner,
clearing ports of any obstructions.
Infrared back burner won't light.
Check the burner inlet for obstructions.
Grill may be in a dusty area. Move to a less
dusty area if possible.
TROUBLESHOOTING
Содержание BROILMASTER R3-1
