Empi 199580-001, Руководство пользователя

Страница: 22 / 52

Select User’s Manual
22
Select User’s Manual 23
Operation Operation
Installing the Batteries
batteries before using the Select. In addition, install new batteries whenever the
“Low Battery” icon flashes in the LCD display. For information about charging the
batteries, refer to
Charging the Batteries
in this
Operation
section.
CAUTIONS:
s Do not connect the stimulator to any electrical outlet.
s Do not mix battery types. Use either two alkaline or two nickel metal
hydride (NiMH) rechargeable batteries.
s Remove the batteries from the stimulator during storage to prevent battery
leakage. Failure to do so may damage the stimulator.
s Replace batteries immersed in water or liquid. Failure to do so may damage
the stimulator.
s Never recharge alkaline batteries. An explosion may result.
s If using rechargeable batteries, carefully read and follow all instructions
provided with the batteries and the battery charger.
s Dispose of batteries according to current federal, state, and local regulations.
Failure to observe these precautions can result in injury, damage to the device and
batteries, or the environment.
To install the batteries into the device:
1. Turn off Select device.
2. Twist belt clip 90 degrees to either the right or left (two clicks).
Fig. 1
3. Gently press down and slide the battery compartment toward you.
Fig. 2
4. At this point, you have the option to remove the belt clip by sliding it
to the left. If you want to keep the belt clip on the device, simply leave it turned at
a 90-degree angle.
Fig. 3
5. Insert batteries, making sure positive and negative ends match the label
inside the battery compartment.
6. Line up all four tabs on the side of the battery cover so they slide into slots in body
of device. Cover should be flush with back of device. Slide up until cover clicks.
(Return belt clip to original position if using.)
Fig. 4
Connecting the Lead Wires to the Electrodes
To connect the lead wire(s) to the electrodes:
1. Decide if you are using one lead wire (two electrodes) or two lead wires
(four electrodes). Follow clinician’s instructions.
2. Locate the pins at the ends of the lead wire(s). If necessary, refer to the
image in the
System Components
section.
3. Locate the pin insertion points on two or four electrodes as necessary.
NOTE:
Refer to the electrode package for complete instructions.
4. With the electrodes still attached to the protective backing, insert one
lead wire pin into each electrode’s insertion point. Insert the pins
entirely so that no metal shows.
NOTE:
Connect only one lead wire to each electrode.
5. Connect the lead wires to the electrodes before applying the electrodes
to the skin. This will reduce the possibility of dislodging the electrodes.
Tabs
Figure 1 Figure 2
Figure 3 Figure 4
user_manual_NEW_BH_edit_r5.indd 22-23 3/3/08 2:08:42 PM
The Select operates with two “AA” alkaline (or rechargeable) batteries. Install the